If the band has recently had problems with the washer, you may wonder how to control the starting it.The motor capacitor in a washing machine to get the engine up to speed quickly before transferring power to the condenser. When the starting capacitor fails, the temptation is to replace the motor, as it buzz, but will not start. Before considering the decision to replace an expensive motor, capacitor check to see if this is the problem.

Need tools

needle-nose pliers with insulated handles

bridge insulated alligator clips at each end

Apartment with an insulated handle screwdriver

Multimeter

Paso. 1

Unplug the machine and remove the back panel for engine access. Remove the metal cover of the starting capacitor. It ‘s the largest of the two capacitors on the motor.

Paso. 2

Draw a diagram of how to wire the motor to the capacitor terminals and disconnect the wires from the terminal with insulated needle nose pliers nose.

Paso. 3

Download the run capacitor that holds a bridge with metal clamp screwdriver and pliers for the other body of the capacitor. Touch the tip of the screwdriver to a number of terminals and the tip of the screwdriver to the other set of terminals near the condenser. This shift in the load capacitor and make it safe to handle without risk of a crash.

Paso. 4

Set the multimeter to the ohms scale and playing the lead of two points together. Move the wheel until the needle is “zero.” The needle should point directly at the center of the sphere.

Paso. 5

Touch the terminals of the capacitor with the wires, the red wire to the left and black on the right. The needle should move from “zero” point and slightly to the right side, then back to zero. Reverse the door and the needle should move from “zero” even more and becomes a “zero.”