The engines are generally produced by the voltage from phase to phase capacitor motor power and not use the two-stage power generation torque when the engine is running, the condenser is called the starting capacitor.

An electrolytic capacitor is a special form that is often used as a wavelet filter in the supply of electricity. It is also used to connect the alternating current (AC) signals direct current (DC) potential, or to filter out low frequency signals in an electrical circuit. Normally, with a value of more than ability to micro farad (MF), the most important feature electrolytic capacitor is polarity.

need for the tool:
schemes
Welding
Welder
Resistant glass
Volt-ohm meter

Instructions
Step. 1
Confirm electrolytic capacitor properly rated as specified in the circuit. Replacing an electrolytic capacitor in a circuit where the values older and now unused mentioned, try to use new electrolytic capacitors that have higher values of the rated voltage. Use of lower voltage than specified may result in an explosion.

Step. 2
Confirm the value of adequate capacity electrolytic capacitor. Note that the electrical patterns have changed and the old values of capacitance 15 mF and 50 mF, for example, were replaced with 16 mF and 67 mF, respectively. In electronic filters, capacitance values are not critical, provided that not less than 20% or more than 80% of the specified values. When electrolytic capacitors without the appropriate capacitance values within the tolerance range of 80% -20% are not available, can be connected in parallel. This efficiency will increase the value of the capacitance at the same voltage. It is dangerous to reduce the amount of capacity and increase the tension by connecting electrolytic capacitors in series, because of the danger of overheating of the electrolytic capacitors and potentially causing an explosion.

Step. 3
Determining the correct position for the polarity of electrolytic capacitors and connect the positive and negative electrodes in the circuit properly. Not doing so may create excessive pressure within the housing of the capacitor and cause an explosion. electrolytic capacitor electrodes “are clearly marked as positive and negative. Refer to wiring diagram, it is imperative that the positive electrode of an electrolytic capacitor that is connected to the higher voltage circuit potential. do not cause a circuit malfunction and other electrical components.

Step. 4
Place the properly electrolytic capacitor circuit card or chassis of the electrical components and solder in place. Do not use excessive heat while welding electrodes, so do not damage the electrolytic capacitor.

Step. 5
Despite shatterproof lenses in order to implement the circuit. If you see sparks or smoke, or if you notice a pungent odor, immediately turn off. The electrical circuit has problems and should be repaired before power is reapplied. If the circuit behaves as expected when power is applied, good electrical performance can be confirmed by specific measuring voltage drops in the measurement circuit pre-determined.